The contact owns a 2024 Hyundai Palisade. The contact received notification of NHTSA Campaign Number: 25V607000 (Seat Belts); however, the part to do the recall repair was available; however, the parts were currently on back order and only a limited number of parts were being released. The local dealer was contacted. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The contact had not experienced a failure.

ALTERNATOR FAILURE: My family and I were moving to [XXX] from [XXX]. A few hours into the drive, the vehicle battery light came on. It was intermittent though. It would be on for a little while 10-15 mins and then shut off and then repeat this process. I stopped at an Autozone and they tested the battery and it was showing a charge of 7%. I could not afford to get stranded somewhere so I went ahead and had the battery replaced, even though I suspected the alternator was going bad. We continued on the trip, but the battery light continued to turn on and off. The vehicle ultimately began losing power about 2 hours after replacing the battery, causing all the warning lights on the dash to turn on, the main center console display lost power and then I lost power steering. All of this happened while I was on the interstate, putting myself and my family in serious danger. I was able to pull the car off an off ramp and park it safely. I called a tow service to take it to the nearest Hyundai. The dealership verified the alternator was bad, but later found that the tensioner assembly had also failed and would have caused serious damage if they had not caught it. The vehicle has since been repaired under warranty, but I researched and found this is a common failed item. The vehicle only has 33,253 miles on it, and is barely 2 years old. Alternators should not fail like that. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

Unexpected shaking and longer stopping distances / unable to properly apply my brakes when I try to break over bumpy surfaces.

I am writing to report a serious safety defect regarding my 2024 Hyundai Palisade. While driving at approximately 6 mph, the vehicle went over a bump in the road. Immediately after hitting this bump, the vehicle began violently shaking and steering out of control. This shaking did not stop or diminish on its own. I immediately attempted to apply the brakes, but the brake pedal became extremely hard to press, requiring significant physical effort to slow down. The violent shaking only ceased once I managed to bring the vehicle to a complete stop.This condition represents a severe, immediate safety hazard. I frequently have my children in the car and use this vehicle for work travel, which requires utilizing highways with speeds greater than 60 mph multiple days of the week. This failure caused a sudden loss of vehicle control and a compromised braking system. I am terrified of the catastrophic consequences if this violent shaking and brake failure happen again at highway speeds with my children inside.Component / System Failure:UNKNOWN. The exact mechanical or electronic system that malfunctioned is currently unknown. The vehicle is parked and is available for inspection upon request.Warning Lamps / Prior Symptoms:There were no warning lamps, error messages, or other symptoms of the problem prior to the failure. It occurred suddenly and without warning.Testing / Inspection Status:The problem has not yet been reproduced or confirmed by an independent service center, nor has the vehicle or component been inspected by the manufacturer, police, or insurance representatives. The incident occurred over the weekend, and I am taking the vehicle directly to the Hyundai dealership for a full safety check on Monday morning as soon as they open.

The contact owns a . The contact received notification of NHTSA Campaign Number: ( ); however, the part to do the recall repair was unavailable. The local dealer was contacted and it was confirmed that the part was not available. The contact stated that the manufacturer exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The contact had not experienced the failure.