Trailer brakes continuously fault due to known problem GM technical bulletin 23-NA-149 This should be a recall. Nothing but the runaround getting it fixed by GM.

While driving I saw smoke and when I pulled over I seen fuel leaking from the gas tank area. Where it was leaking it ignited and the fire department had to put out the fire and the truck is totaled

The contact owns a 2023 GMC Canyon. The contact stated while driving at an undisclosed speed, the vehicle failed to accelerate as intended while depressing the accelerator pedal, and the automatic emergency braking (AEB) unexpectedly engaged. The message "Reduce Acceleration Proceed with Caution”, and the check engine warning light was illuminated. The vehicle was turned off and restarted and returned to normal functionality. The contact stated that the vehicle was nearly rear-ended. The vehicle was not taken to the dealer or an independent mechanic. The vehicle was not repaired. The contact related the failure to NHTSA Campaign Number: 24V133000 (ELECTRICAL SYSTEM, FORWARD COLLISION AVOIDANCE); however, the VIN was not included. The manufacturer was made aware of the failure. The failure mileage was approximately 9,300.

Coolant leak observed at the upper radiator hose quick-connect fitting. The leak appears to originate from the internal seal at the radiator inlet connection. This issue developed without warning and is consistent with a known defect in the radiator hose seal design used in 2023 GMC Canyon vehicles. Vehicle experienced coolant loss and visible residue at the connection point. No visible external damage to the radiator or hose assembly was observed. GM has issued a Special Coverage program for similar radiator inlet hose seal failures in related vehicles using the same component design. Concern is that this defect may lead to coolant loss and potential engine overheating if not addressed.

The upper radiator hose on some huge percentage of these trucks fail (mine has failed at just over 37K miles). You can check the Colorado Chevy and GMC Canyon forums, youtube, Facebook, etc., et al, and find plenty of instances where this has failed. As this is the cooling system, it can cause the engine to overheat and potentially ruin the engine. The flaw seems to be an engineering issue with the rubber seal they use (instead of a high quality o-ring) to seal the upper hose to the radiator. Additionally, since this can cause engine failure it should be addressed immediately. Instead, my local Chevy dealer, since its not a recall item, said they could schedule a time next week for me to LEAVE the truck and that I am responsible for the repair. This is extremely unfair to the consumer who depends on these vehicles. This should absolutely be a recall item. You can find 1000's of examples online and if you can pull GM repair data, I'm sure you'll find 1000's more.