The electrical system in my 2023 Mitsubishi Outlander has repeatedly malfunctioned since September 2023. The primary failure involves the dashboard completely shutting down while the vehicle is in motion, resulting in the loss of critical driving information such as speed and system warnings. The issue is intermittent but ongoing and may be available for inspection upon request. This failure creates a serious safety risk because I am unable to see essential driving information while operating the vehicle, placing both myself and my family at risk. The vehicle has been taken to authorized Mitsubishi dealerships multiple times for these issues. Repairs have been performed during these visits; however, none have permanently resolved the problem. The issue temporarily stops after repairs but eventually returns and continues to recur. The problem has been reproduced multiple times. The vehicle has been inspected by authorized Mitsubishi service departments on multiple occasions, but the underlying issue has not been properly diagnosed or permanently repaired. Prior to failure, there have been repeated battery-related issues and sensor malfunctions. The vehicle has required at least three battery replacements since purchase. These symptoms often occur before the dashboard shuts down. In addition to the electrical issue, the vehicle has also experienced fuel pump concerns, which have persisted despite repair attempts. This ongoing and recurring defect makes the vehicle unsafe to operate and remains unresolved.

The rear braking system failed due to a sticking/seizing brake caliper. An independent inspection confirmed a severe thickness discrepancy: the outer pad was worn down to 3mm, while the inner pad remained at 7mm. This occurred at only 7,343 miles. I have the physical brake pads provided by the dealer; however, I have photographic proof that the dealer provided fraudulent, evenly worn pads upon vehicle pickup to tamper with evidence. Both the fraudulent pads and the original photos of the defective pads are available for inspection. The sticking caliper causes uneven braking force, increased stopping distances, and premature brake failure. This is a severe safety risk that could lead to a loss of vehicle control or a collision, especially under emergency braking conditions. Furthermore, the dealership's attempt to conceal this defect by swapping parts prevents proper safety documentation and potential recall actions. An independent service center (certified technician) confirmed the 3mm/7mm wear delta on March 19, 2026. The dealer (Northstar Mitsubishi) also initially confirmed the defect and processed it as a $0.00 warranty repair (Invoice #6048308) before rescinding the coverage and demanding payment. The vehicle was inspected by the authorized dealer (Northstar Mitsubishi) and an independent repair facility. I am currently requesting a formal inspection by Mitsubishi Motors North America (MMNA) corporate. There were no dashboard warning lamps. The primary symptom was an excessive amount of brake dust accumulating on the rear wheels compared to the front, and a noticeable physical thickness difference between the inner and outer brake pads. These symptoms were first observed around 7,000 miles during a routine inspection. The defect was confirmed by an independent technician's measurement of 3mm (outer) vs 7mm (inner).

Extremely heavy steering on highway. Steering wheel slow to return to center and sometimes will stay "locked" into turn, requiring to turn the wheel manually back to center.

The EV portion of the PHEV is often not providing power to the motors, even though, there are still plenty of battery power available. The vehicle sometimes gave "Power Reduced" warning that usually went away after 30 minutes, and the vehicle cannot go into EV mode. When in EV mode and just cruising on the highway, it barely has power to keep up with traffic and sometimes it is losing speed just on a slight incline on the road causing me to move over or take it out of EV mode just to get power from the gas engine. In one occasion, I driving in EV mode and merging onto the highway. I stepped on the gas and the car was barely, if at all, accelerating. Fortunately, there wasn't vehicle coming from the highway.

A software issue in the Alliance in-vehicle Infotainment (A-IVI) Display unit cause the sirven to freeze or display black during a backing event